Assembly Instructions
5
Assembly of the GA-800 is straightforward, and all the parts attach to the base assembly, part
#1
shown
in Figure 1. If after reading the assembly steps below, please refer to the parts list in the back of this
manual if you have any questions about assembly. The parts list presents part information, described in
the sections below, in a visual manner such that you can understand the assemblies better.
1.
Install the legs to the base assembly if not already installed.
2.
Attach the seeder slides and bait box to the base assembly.
From the parts package, you will need the 2 seeder slides (labeled L in Figure 2), 4 springs (labeled K),
and 4 serrated, flanged hex nuts (labeled J). You will also need the bait box.
a)
Install the four springs to the attachment points on the seeder assembly. These attachment
points are found just behind the clear hoses that deliver the bait to the seeder tube.
If they are already installed slide and lock them into position to hold the gopher getter upright. When the
legs are in position, the GA-800 will look as pictured in Figure 3.
Figure 3: GA-800 Base Assembly with Legs
