Assembly Instructions
5
Page 44 of 97
Operating Instructions
enCore FC1
Fig. 5-4: Removed board frame
►
Check the position for the additional board (number of board slot).
Set up the board number on the board
Note that the number of the board slot as well as the board
number on the board must be set; this is essential for further
functioning of the internal I/O bus communication.
►
Insert the relevant jumpers in the suitable pin connector in order to
define the number on the board (
refer to Fig.
=
jumper
board position
(slot no.)
1
2
3
4
5
6
7
Fig. 5-5: Pin connector with jumper positions