5
Assembly Instructions
enCore FC1
Operating Instructions
Page 45 of 97
►
Remove the cover plate of the respective slot (2 screws).
►
Insert the board with the side meant for the process connection in the
slot on the rear panel (blue plug for Ex boards, otherwise green plug,
refer to Fig. 5-2).
►
Make sure that the orientation of the board (top/bottom) is correct:
On the opposite side the pin connector for the I/O bus connection (with
safety clamp) must face downwards to the bottom of the device tray
(
, Position B). The pin connector must face upwards
for defining the board number (
, Position C).
Fig. 5-6: Interior view of the board cage
pin connector for I/O bus connection (with safety clamp)
pin connector for defining the board number
(in Fig.
: 4 boards)
C
B
C
B