![background image](http://html1.mh-extra.com/html/elsner-elektronik/sewi-knx-l/sewi-knx-l_installation-and-adjustment_2396617019.webp)
17
Parameter setting
Sensor Sewi KNX L
• Version: 10.09.2018 • Technical Changes and Errors excepted.
6.2.
General settings
Set basic characteristics for the data transfer.
6.3.
Light control
For light control, the
Sensor Sewi KNX L
detects the brightness in the room.
Activate the light control.
Set, in which cases the
data
received via object for setpoint value, setpoint value-ac-
tual difference, dimming increment and times are to be retained. Please note that the
setting "After power supply restoration and programming" should not be used for the
initial start-up, as the factory settings are always used until the first communication.
Set the
setpoint value for the brightness in the room
and specify whether, besi-
des the dimming information defined below, a switching object should also be sent.
With
Sensor Sewi KNX L
, the regulation is always started or stopped by an object.
Set the object evaluation and the object value prior to the first communication.
At the end of the regulation, either "nothing"(status remains unchanged), an on or off
command (via the activated switching object) or a dim value can be sent.
Send delay after power-up and programming for:
Measured values
5 s • ... • 2 h
Threshold values and switching outputs
5 s • ... • 2 h
Computer objects
5 s • ... • 2 h
Logic objects
5 s • ... • 2 h
Maximum telegram rate
• 1 message per second
• ...
• 5 messages per second
• ...
• 20 messages per second
Use control
No • Yes
Maintain the
data received via object setpoint value,
setpoint value-actual difference, dimming
increment and times
• never
• after power supply restoration
• after power supply restoration and
programming
Setpoint value in Lux
0...60000; 500
Send switching object
No • Yes
Regulation starts on
Reception of a start/stop-object
Regulation stops on
Reception of a start/stop-object