![background image](http://html1.mh-extra.com/html/elsner-elektronik/sewi-knx-l/sewi-knx-l_installation-and-adjustment_2396617021.webp)
19
Parameter setting
Sensor Sewi KNX L
• Version: 10.09.2018 • Technical Changes and Errors excepted.
Note: If the criteria for the continuation of the regulation are fulfilled, the regulation,
however, has just been stopped by an object or is blocked, then the end of the inter-
ruption has no effect on the behaviour of the light.
The light regulation can be
blocked
via the bus. In contrast to the interruption, when
blocking, a switching command or brightness value can be sent. The output behaviour
follows the rule upon release.
6.4.
Brightness Measurement
The
Sensor Sewi KNX L
detects the brightness in rooms, for example for controlling
lights.
Set the
sending pattern
for the measured brightness.
The brightness reading can be
corrected
in order to compensate for a dull or bright
point of installation for the sensor.
Set, in which cases the correction factor
received via object is to be retained. Please
note that the setting "After power supply restoration and programming" should not be
used for the initial start-up, as the factory settings are always used until the first com-
munication (setting via objects is ignored).
Specify the starting correction factor.
Use block
No •
Yes
Analysis of the blocking object
• at value 1: block | at value 0: release
• at value 0: block | at value 1: release
Value prior to initial communication
0 • 1
Output pattern
On block
• send nothing
• send off command
• send on command
• send value
Sending pattern
• never
• periodically
• on change
• on change and periodically
at and above change in %
(if sent on change)
1 ... 100; 20
Send cycle
(if sent periodically)
5 s ... 2 h
Use reading correction
No • Yes
Maintain the
correction factor received via
communication object
• never
• after power supply restoration
• after power supply restoration and
programming