62
Parameter setting
Sensors Intra-Sewi KNX TH-L-Pr and Intra-Sewi KNX L-Pr
• Version: 30.08.2018 • Technical changes and errors excepted.
5.16.1. Control variable comparator 1/2
Determine what the control variable comparator should output, and activate the input
objects to be used. Transmission patterns and blocks can also be set.
5.17. Logic
The device has 16 logic inputs, four AND and four OR logic gates.
Activate the logic inputs and assign object values up to first call.
Activate the required logic outputs.
AND logic
Output delivers
• Maximum value
• Minimum value
• Average value
Use input 1 / 2 / 3 / 4 / 5
No • Yes
Output sends
• on change of output
• on change of output and periodically
• when receiving an input object
• when receiving an input object and
periodically
Send cycle
(if sent periodically)
5 s • 10 s • 30 s • ... • 5 min • … • 2 h
At and above change of
(if sent on change)
1% • 2% • 5% • 10% • 20% • 25% • 50%
Analysis of the blocking object
• at value 1: block | at value 0: release
• at value 0: block | at value 1: release
Blocking object value
before 1st communication
0 • 1
Behaviour of the switching output
On block
• do not send message
• Send value
Sent value in %
0 ... 100
output sends on release
(with 2 seconds release delay)
• the current value
• the current value after receipt of an object
Use logic inputs
Yes • No
Object value prior to first call for:
- Logic input 1
0 • 1
- Logic input ...
0 • 1
- Logic input 16
0 • 1
AND logic 1
not active • active
AND logic ...
not active • active
AND logic 4
not active • active
Summary of Contents for Intra-Sewi KNX L-Pr
Page 2: ......
Page 6: ...6 Clarification of signs ...
