Installation
ELSA LANCOM DSL/10 Office
10
Configuring the basic settings using telnet
If you do not wish to or cannot use
ELSA LANconfig
(e.g. because you have installed a
different operating system), you can also make the basic settings over a telnet
connection.
Start the telnet connection to the address '10.0.0.254' if you have not previously used IP
addresses in your network, or to address 'x.x.x.254', where 'x.x.x' stands for the address
group previously used in the network.
Enter the following command:
You can start the telnet connection with the command
Start
-
Run
and entering
the command
telnet 10.0.0.254
in the window.
Change the language for the configuration with the command:
set /Setup/config-module/language english
Intranet address and network mask:
set /setup/TCP-IP-module/Intranet adr. 10.0.0.1
set /setup/TCP-IP-module/Intranet mask 255.255.255.0
After changing the Intranet address, the telnet connection is terminated by the router and
you will need to establish a new telnet connection to the set Intranet address.
To switch off the DHCP function:
set setup/DHCP-module/operating off
Set up provider in the name list:
set /Setup/WAN module/name list internet 20
Input access data into the PPP list:
set /Setup/WAN module/PPP list Internet no 'your password'
0 5 'your user name'
Set route into Internet:
set
/Setup/IP-router-module/IP-routing-tab
255.255.255.255
0.0.0.0 internet 0 ON
Even if the entries at this point are not very clear without further explanation, you can
reach the same destination as with the setup with ELSA LANconfig: This establishes
access to the Internet for the first time!
