Description of the menu options
ELSA LANCOM DSL/10 Office
R48
Version table
The version table displays the firmware version and serial number of the device.
Table firmsafe
This table provides the following details for the two firmware versions stored in the
device: the position in memory (1 or 2), status information (active or inactive), the version
number, the date, the size and the index (sequential number).
Enter the following command to activate an inactive firmware version:
set <position number> active
on.
Mode-firmsafe
Only one of the firmware versions stored in the device can be active at any one time.
When new firmware is loaded the inactive firmware is overwritten. You can decide
which firmware will be activated after the upload:
K
'immediate': The first option is to load the new firmware and activate it
immediately. The following situations can result:
– The new firmware is successfully loaded and then operates as desired.
Everything is then in order.
– However, if the new firmware does not operate correctly, it may not be possible
to communicate with the device after the restart. If an error occurs during the
upload, the device automatically reactivates the previous firmware version and
reboots the device.
K
'login': To prevent problems caused by defective firmware, the second option will
load the firmware and start it immediately.
– In contrast to the first option, the firmsafe will wait until it has successfully
logged on over outband or inband (by telnet). In contrast to the first option, the
firmsafe will wait until it has successfully logged on (by telnet). The new
Timeout-firmesafe
Time in minutes required to test new firmware
Test-firmware
Tests the inactive firmware
Firmware-upload
Initiates a firmware upload
/Firmware
Display and keyboard settings
Ifc
Module
Version
Serial number
Ifc
LANCOM DSL/10 Office
1.70.0006 / 01.09.1999
8427.000.020
Position
Status
Version
Date
Size
Index
1
Inactive
1.70
30081999
535
6
2
Active
1.70
01091999
366
7
3
<Lader>
1.60
01091999
64
0
