Elo TouchSystems Entuitive 1229L, User Manual

Page: 104 / 249

1
SECTION 1. FEATURES AND SPECIFICATIONS
The Port Powered Swipe Reader is a compact magnetic stripe card reader which conforms to
ISO/ANSI standards. The Reader is compatible with the PC series of personal computers or any
device with a serial RS-232 interface. A card is read by sliding it, stripe down and facing the
LED side, through the slot either forward or backward.
A green LED (Light Emitting Diode) indicator on the Reader panel provides the operator with
continuous status of the Reader operations.
When power is applied, the Reader transmits a sign-on ID message. About 150 milliseconds
after DTR is applied, the Reader sends the part number of the firmware in the following form:
21088819A01 <CR>. The first 8 characters indicate the firmware number; the letter is the
revision, which is followed by a revision sublevel of 01 to 99. The <CR> indicates carriage
return (0x0D). The sign-on messages for part numbers are listed in Section 3. Timing is also
shown in Section 3.
Since the input voltage is supplied by a relatively low source of power, the Reader depends on its
input capacitor to maintain proper charge during all operations. In order to reduce the drain on
this internal power source during data transmission, the output data is transmitted in 5 to 6
millisecond bursts with a 10-millisecond gap between bursts to allow the capacitor to recharge.
The PC software should be able to tolerate this 10-millisecond space between characters. The
Timing is shown is Section 3, Figure 3-1. Configurations, including part numbers, firmware,
tracks, and unit configuration, are listed in Section 3, Table 3-2.
MAG-TEK DEVICE DRIVERS FOR WINDOWS
The Mag-Tek Device Drivers for Windows, Part Number 30037385, may be used with the Port
Powered Swipe Reader. When this program is used, refer to
Mag-Tek Device Driver for
Windows, Programming Reference Manual , Part Number 99875125.
FEATURES
Major features of the Swipe Reader are as follows:
•
Powered through the RS-232 serial port – no external power supply required
•
Hardware Compatible with PC or any computer or terminal with an RS-232 interface
•
Software Compatible with Procomm, or any RS-232 communications program
•
Bidirectional card reading
•
Reads encoded data that meets ANSI/ISO/CDL/AAMVA standards
•
Green LED for status