ANNEX
ޓ
CLEARANCE BETWEEN FEED DOG AND NEEDLE PLATE
1. To adjust a clearance between feed dog and needle plate, set SL dial at
"5"
and DF dial at
"1"
. Turn the handwheel towards you until feed dog moves to far
rear position. Loosen screw
"k"
and move feed bar
"m"
back and forth to
obtain a clearance
" F "
of
0.3 to 0.5 mm
. (Fig. 1) Fasten screw "
k
".
2. Turn the handwheel towards you until feed dog moves to far front position. Check
and make sure if a clearance between feed dog and needle plate is 0.7 mm.
(Fig. 2)
0.7
Fig.1
0.3~0.5mm
Fig.2
3mm
F
m
k
Summary of Contents for 745 -
