Elmo T-200, Instruction Manual

Page: 21 / 78

Raising the projected image
Projected image can be raised up when using the built-in tilt stand underneath the
projector.
Bottom of the projector
1. Use the tilt stand
Setting up the tilt stand allows you to raise the projected image.
The two position tilt stand allows you to set up the projectionangle to
either 5°or 10°.
The greater the angle, the higher the image is projected.
2. Reset the position of the projected image.
The projector will project horizontally when the tilt stand is folded to the first
position.
Keystone distortion can occur when using the tilt stand.
Adjust keystone settings to correct keystone distortion.
Refer to CORRECTING THE KEYSTONE DISTORTION
(Page30 43) for details.
N o t e
Tilt stand 10°)
Tilt stand 5°)