If the range is not level, adjust leveling legs up or down with
pliers or your fingers until range is level.
NOTE: Oven must be level for satisfactory baking performance.
Electrical and Gas Connection Locations
ELECTRIC COOKTOP
Surface Elements
Controls
Control knobs must be pushed
in before turning them to
a setting.
They can be set
anywhere between MAX and
MIN.
The controls for the surface
elements provide infinite heat
settings. The numbers on the dial serve as a reference. The
control can be turned to any setting to provide the exact
heat required.
NOTE: The “Push to Turn Safety Control Knobs” on
the range are designed for child safety and to prevent
accidental operation.
Before using your glass cooktop for the first time: turn
the elements on MAX without a pan for 5 to 8 minutes
or until smoking stops. This smoking is normal and
non toxic.
High Speed Radiant - Electric Top Burners
Consists of a set of special RADIANT HEATER coils
embedded in thermal insulation. The element is designed
for fast heat response. You can see it light up almost
immediately.
Each element is fitted with a thermal limiter to ensure
the ceramic glass does not exceed the maximum SAFE
operating temperature. You may notice the element going
on and off a number of times during use. This is a normal
occurrence.
To maximize the efficiency of this type of element we
suggest you use it similarly to your previous burner. Turn to
maximum until the desired temperature is reached, then turn
it down to the setting that best maintains the desired heat.
• H or 9 – To start foods cooking and to bring foods
to a boil.
• 8-7 – To hold a rapid boil.
• 6-5 – To fry foods.
• 4
– To cook large amounts of vegetables
• 3-2 – To keep food cooking after starting it
on a lower setting.
• L
– To keep foods warm until ready to serve.
Controls
The radiant heating elements are controlled by a commonly
used Infinite Heat Switch that works on the principle of
percent on, percent off. For example, when the switch is
turned to the medium setting, the element will be on only
50% of the time. Because of the fast heat-up with these types
of elements, you will notice the units switching on and off.
10
Gas line connection is
33" off of the floor and
3.5" in from the right
hand side of the range.
Dual Fuel Range 1947, 1955
Electrical Cord is 12"
up from the floor.
1.5"
1954 All Electric and
1947, 1955 Dual Fuel Ranges
have 220V 4 prong cord.
Plug depth is 1 1/2" and
cord length is 4 feet.
All Gas Range 1956
Electrical Cord is 12"
up from the floor.
Regulator is centered and
approximately 2" in under
the range.
1"
1956 All Gas Model
110V Plug depth is
1" and does not recess
into the range.
Cord length is 3 feet.
