Elma 1352C
30
Datalogger & Interval setup
How to store data in memory and how to recall data from memory.
There are two different ways of storing data.
Auto store:
Auto store Interval time setup:
1.
Press
button,
“
Int
”
appears for interval, as well as a flashing second display.
2.
Now set the desired recording interval in minutes and seconds. Press
or
to
increase or decrease number, Max 1 minute can be set. The minimum value is limited to
“00:01”(=1s). After setting has been performed, actuate the press
button once, to get
back to the display of the instantaneously measured values. If you want abort during a
setup process, press
button to cancel.
When one presses the button starts saving the measured values .The values are stored
in a memory location. Press
button again will stop recording.
Note:
During recording period, most of the buttons such as the , , , , are
inoperative. All other settings must be made before starting the record operation.
LCD will show FULL symbol when 31000 recorders are stored in memory.
Clearing Stored Data (From Auto Store):
If you want to clear the memory, power off the unit, then press and
hold button and then press button and hold at least 5 seconds,
then LCD will show "
CLr
" and “
SURE
” to clear the memory.
Manual store
Press the button to store measurement data using manual store.
Up to 99 data sets can be stored in the internal memory.
Reading Stored Data ( From Manual Store ):
1.
Press the button. The
“ ” symbol appears.
2.
Press the or buttons to select the data number in which the
data were stored. The data are shown on the LCD. When there are
no data in a number the LCD shows
“ 00 ”
3.
To terminate the recall mode, press the button once more.
Note:
The battery indicator
“ ” shows the remaining battery power. The
number of black bar decreases as the battery running out. When the
power is almost empty,
“
” will disappear. Press
or
button, LCD display will show
“
Lo bat
” warning indication. If the
meter is under record mode, it will stop.
Clearing Stored Data (From Manual Store):
If you want to clear the memory, power off the unit, then press and hold
button and then
press
button and hold at least 5
seconds, then LCD will show “ CLr ” and “ SURE ” to
clear the memory.
