8. Blade Assembly.
page 7
9. Light Kit Assembly.
molex
connections
switch
housing
fitter
plate
switch
housing
plate
motor
housing
motor
housing
blade arm
blade
lock washer
blade arm
screw
blade attachment
screws and washers
Time Saver
: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws (along
with washers) with fingers first and then tighten
screws securely with Phillips screwdriver. Repeat
procedure for remaining blades.
Align blade arm holes with motor screw holes and
attach blade arm with lock washers and blade arm
screws that were previously removed (page 4).
Before securing screws permanently, repeat
procedure with remaining blade arms. Securely
tighten all screws.
Note
: Tighten blade arm screws twice a year.
Remove 3 screws from outer edge of switch housing
plate and set aside.
Remove 1 screw from fitter plate (on underside of
motor) and loosen the other 2 screws. Align slotted
holes in center of switch housing plate with loosened
screws on fitter plate, allowing the molex connections
from the motor housing to come through hole in
middle of switch housing plate. Twist switch housing
plate to lock. Re-insert screw that was just removed and
tighten all 3 screws securely.
Locate
BLACK
(or
BLUE
) and
WHITE
wires in motor
housing labeled FOR LIGHT. Remove and discard plastic
that holds these 2 wires together.
Note
: If you wish to use the fan
without
the light kit,
remove switch housing from light kit fitter and place the
plug (provided in a hardware pack) in center hole of
switch housing. See instructions in last paragraph of this
page to attach switch housing to switch housing plate.
Connect
WHITE
wire from motor housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
) wire
from motor housing to
BLACK
wire from light kit fitter.
Make sure that molex connections are secure.
Align holes in switch housing with holes in switch
housing plate, making sure to align the red dot on the
inside of the switch housing with the red dot on the
underside of the switch housing plate. Re-insert screws
that were previously removed to secure switch housing
to switch housing plate.
["Light Kit Assembly" continued on next page.]
light kit fitter
