10
Monitor Wiring –
Place a 10A fuse between the red lead (pin C) of the monitor and a switched positive power
lead on the vehicle. Attach the black lead (pin A) from the monitor base to the vehicle ground.
The white lead (pin B) is for an optional “Stow Indicator” which could be attached to a relay or
LED supplied by the OEM. The circuit switches in a ground, and is limited to 250 mA of current
when the monitor is in a non-stowed position.
All control functions are sent to the monitor via an encoded RF signal from the RF controller,
and no control wiring is needed.
Panel Mount RF Controllers –
Using the Panel Mount RF Controller template in the Component Mounting Templates section,
mark the panel cutout and mounting screw locations.
Cut a rectangular clearance opening and drill four (4) 7/32” holes.
Insert fixed RF controller case through the panel cutout. Secure the unit to the panel with four (4)
#10-32 screws. The length of the screws should be the panel thickness plus 3/16”. The screws
supplied are ¼” in length. Apply Loctite 242 or equivalent to screw threads before tightening
them.
The controller antenna is to be mounted using the 10’ antenna cable provided. Locate one of
the antennas outside the vehicle compartment, and in a position that provides the least
obstructed line of sight to the monitor’s antenna.
Place a 1A fuse between the red lead of the RF controller and a switched positive power lead on
the vehicle. Attach the black lead from the monitor base to the vehicle ground.
All control functions are sent to the monitor via an encoded RF signal from the RF Controller.
OEM RF Transmitter –
Place a 1A fuse between the red lead of the transmitter and
a switched positive power lead on the vehicle. Attach the
black lead from the monitor base to the vehicle ground.
Connect all of the switch commons to the ground (black)
connection.
Connect each function to a corresponding switch. To
operate the function, close function’s switch to ground. Any
combination of pushbuttons or toggle switches can be
used.
Power indication can be created by attaching an LED and
proper resistance between the VCC (+3V) and ground
connections. Max rating for the VCC connection is 250mA.
The transmitter’s antenna is to be mounted using the 10’
antenna cable provided. Locate one of the antennas
outside the vehicle compartment, and in a position that
provides the least obstructed line of sight to the monitor’s
antenna.
Table 2: OEM RF Transmitter switches
Function
Wire Color
Ground
Black
VCC (+3V)
Output
Red
Right
Brown
Down
Orange
Up
Yellow
Left
Green
Stream
Blue
Fog
Violet
Aux 2
Grey
Oscillate
White
Aux 1
White/Black
Stow
White/Brown
