17
Figure 5: System LED Notations
Table 3: DS5 Status Indicator LED Table
Handheld Controller
Battery Type
The handheld controller uses two AA Lithium batteries. The low battery light will illuminate with
approximately two hours of transmission time remaining before the batteries are completely
discharged. Due to the time-voltage characteristics of rechargeable batteries, this time could be
drastically reduced if rechargeable batteries are used.
Battery Replacement
The batteries can be replaced with any standard fresh AA Lithium batteries.
Turn the controller power off.
Remove the battery cover.
Remove both of the old AA batteries.
Wait 5 minutes, and then install new AA Lithium batteries.
Replace the battery cover.
DS4
DS2
DS3
DS6
SW1 DS1
SW3
DS5
SW4
B
P4
P1
P3
P2
A
SW2
Reference
Indication
Meaning
1
Light comes on for 1 second when
monitor stops
Motor has reached stall current and
performing normal shutdown.
2
Blinks 3 times after pressing and holding
Red Programming Button for more than 5
seconds.
Limit/stow programming sequence initiated.
NOTE: This must be completed before normal
monitor operation is allowed.
3
Blinks 3 times per second during startup
Visual indication that the controller is
initializing – normal operation.
4
Blinks 2 times per second during startup
then blinks at ¼ second rate continuously
SW4 in wrong position – must be in position E
or 8 for proper 8593-04 monitor operation.
5
Blinks at ½ second rate
Truck battery voltage is <8 volts – light will
blink until power is lost or is restored – early
power fail (EPF) indication.
