25
25
Section 2: Setup and Preparation for Operation
Installing the Barcode Reader
A barcode reader can be connected to the stainer for scanning reagent bottles and specimen slides that
contain barcodes. This allows easy reagent and specimen information tracking. If a barcode reader is not
installed, reagent and specimen information can be entered manually (Section 3.2).
1. Place the barcode reader and stand on a level surface near the stainer.
2. Plug the barcode reader into the
left
USB port on the rear panel of the stainer. See Section 3.2 for
instructions on using the barcode reader.
Preparing the Stainer for Operation
Priming Procedures
NOTE:
The instrument is shipped with alcohol in the reagent lines. For proper performance, this alcohol
must be replaced with the correct reagent for each reagent line prior to use.
Thoroughly purge and prime each reagent delivery line using the following instructions.
1. Remove each spray nozzle with the provided nozzle tool by turning
counterclockwise.
2. Note the location of each nozzle so it can be returned to the original position
during reassembly.
3. Place a carousel on the stainer hub to prevent stain from entering the motor
shaft.
CAUTION:
Fluid from priming can flood and damage the motor if the drain tube is not properly installed.