EN
ENGLISH
19
equipment generates strong magnetic waves
and interference that may give rise to incorrect
readings. Do not use the device and the conso-
le within a distance of about one and a half
metres from other transmitters.
Do not use other wireless equipment at the
same time. This may give rise to incorrect
measurements. Do not expose the unit and the
console to direct sunlight for long periods
when they are not in use. Check the position
and assembly conditions of the frequency sen-
sor and magnet at regular intervals. Never use
chemical detergents (benzene or thinners) on
any part of the Elite RealTour.
MINIMUM SYSTEM REQUIREMENTS
Processor:
Pentium IV @ 2,4 Ghz
Operative system:
XP, Vista o 7
Hard disk:
7200rpm
Ram:
512 MB
Monitor:
1024x768
Drive:
DVD-ROM
Graphic card:
32MB of memory
Various:
1 free USB port
PARTS LIST
Your RealTour electronic trainer is made of the following components:
N°1 RT Unit frame – Ref. A
N°1 Unit support plate – Ref. B
N°1 M8x70 screw –Ref C
N°1 ø8 washer – Ref. D
N°1 M8 nut - Ref. E
N°1 Ferrule - Ref. F
N°1 Left pin bush – Ref. G
N°1 Right pin bush – Ref. H
N°1 Fixing Lever – Ref. I
N°1 Resistance unit – Ref. J
N°2 M6x16 Screw – Ref. K
N°2 ø6 washer – Ref. L
N°1 Hex key
N°1 Handlebar console – Ref. M
N°4 Standard feet – Ref. N
N°4 Ritmo feet – Ref. O
N°1 Cadence sensor - Ref. P
N°1 Magnet – Ref. Q
N°1 PC-Console USB cable – Ref. R
N°1 Console-Resistance Unit 8 pin cable – Ref. S
N° 2 Dvd-Rom – Ref. T
N°1 Cadence sensor instruction sheet – Ref. U
N°1 Instruction manual – Ref.V
N°1 Travel Block – Ref. W
N°1 Quick Release – Ref. X
N°1 Power charger - Ref. Y