Elite Spas Platinum I, Owner'S Manual

Page: 15 / 26

Waterfall Feature
The waterfall feature allows you to independently control it for customized soothing effect. The Jets1 button activates the waterfall
feature. Waterfall flow can be adjusted rotating on-off valve located near main control panel of spa.
Air Control
Certain jet systems have their own air control valve. Each control introduces air into the water lines that supply that specific jet group.
Simply rotate Air control clockwise to close and rotate counterclockwise to open. To minimize heat loss, all air controls should be
closed when the spa is not use.
Audio System
Spa equipped with audio system offer enhanced spa enjoyment. This model include a high quality AM/FM/CD stereo receiver with
two high quality speakers for unsurpassed sound quality and long life.
Two speakers located on spa corners and designed for manual exposure and retraction. To expose each speaker for audio playback,
simply press download on each enclosure to unlatch it's pop-up mechanism, then release. To retract each speaker before covering spa,
gently press downward on each enclosure you will feel a slight “click”, then release.
Caution: Never step or sit on speaker enclosure. Always retract speakers prior to covering spa.
For details see Stereo Receiver Operational Manual for Users.
ERROR IDENTIFICATION
Three Flashing Dots with Pump Off
Pressure or Flow Switch Activated: If 3 flashing dots appear below the temperature display while there is
no pump operating, turn the pump on. If the 3 flashing dots went away this indicates that the pressure or
flow switch was activated although there was no water flow. (Contact manufacturer).
Three Flashing Dots with Pump On
Pressure or Flow Switch Not Activated: If 3 flashing dots appear below the temperature display while the
pump(s) is operating, turn the pump(s) off. If the 3 flashing dots went away this indicates that the pressure
or flow switch was not activated although there was water flow. Note: A dirty filter limiting the water
flow will also cause this error message to appear. (Contact manufacturer).
104 104
104 104
If the display shows a constant 32 degree F or 125 degree F and this is not the actual temperature or the
displayed temperature greatly differs from the actual spa water temperature, a problem with the water
temperature sensor has occurred. (Contact manufacturer).
High Temperature
If 3 flashing dots appear in the spa side display and the system detected the water temperature in spa
(temperature sensor located in dry well in the spa) 112F or higher the system will shut off the heater and
all other outputs will be disabled until the water temperature drops below 110F.
If 3 flashing dots appear in the spa side display and High-Limit LED indicator is illuminated on the
system circuit board, an overheat condition has been detected. It is not safe to enter the spa until the
error has been corrected. The pumps, blower and other outputs will stay active. Power must be cycled
off then back on for system to reset this error.
32 32
119 119
112 112
10
OPERATING INSTRUCTIONS
Freeze Protection
The system is constantly monitoring the temperature of the water and ambient temperature. If inboard sensor registers an ambient
temperature below 41F the systems “Smart Winter Mode” will activate. This mode once activated, will continue for minimum period
24 hours. The system will activate any pumps connected to the system. All pumps starting for one minute at various intervals based on
the ambient temperature under the spa skirt.
During the “Smart Winter Mode” the AC indicator will flash while the pumps are running in this mode.