Linux DVR System
2.2. Explanation of Contents Displayed on Each Screen (The case when OSD
setting is ON)
SETUP-In general setup, when you change OSD setup to ON, setup value by each camera
channel is displayed on the screen. The contents displayed on the screen are as follows.
SETUP-When you change OSD setup to OFF in general setup, the following contents are
not displayed on the screen.
( Refer to p.4.5 OSD setup)
<DISPLAY MODE of Screen divided into 16> <Contents displayed on each screen>
<Expansion>
③
CAM ID
①
②
R M P S
①
Camera ID : Camera ID that image is flashed is marked at upper left side of concerned
screen. ID of each individual camera can be set up at the discretion of user at SETUP
MODE.
(Refer to p: 5.3. Camera ID Change)
②
Storage status and setup status by each camera channel are shown in alphabet
initials.
R
:
Initial indicating that concerned camera is executing entire storage.
M :
Initial indicating that concerned camera is executing motion storage.
S :
Initial indicating that the sensor is in operation.
P :
Initial indicating that concerned camera is set up with pan/tilt camera.
( Refer to PTZ type/ID setup in p.66: 5.6.)
What is PAN/TILT Camera?
※
Pan/TILT is a rotator that rotates the camera up/down and left/right, and it is a device
for the expansion of monitor scope. It is a device to eliminate the area that camera
image can not catch (dead angle area). The camera equipped with such PAN/TILT is
named as Pan/Tilt Camera.
LeadTech
19