Elin EBG ELVOvert SX, Operating Manual

Page: 54 / 56

Parameter Parameter No. No. Factory default Factory default Clients adjustment Clients adjustment
Motor pole number for d1 A25 4
Ext. f-ref limitation: start value A26 0.0 Hz
Ext. f-ref limitation: end value A27 0.0 Hz
Restart selection A34 0
Braking unit:usage ratio A38 1.5
Signal „Frequency arrival“: On-level A39 0.0 Hz
Signal „Frequency arrival“: Off-level A40 0.0 Hz
Analogue output f/I/T A44 0
Calculation factor n A47 1.0
Frequency reference selection A48 1
„Frequency arrival“ characteristic A49 0
Speed search function A54 0
Start with reduced voltage A58 6
Mode of operation A59 0
JOG-frequency A61 1.00 Hz
Base frequency A62 50 Hz
End frequency A63 50 Hz
Maximum frequency A64 120 Hz
Calibration of f-reference: voltage A80 pre-adjusted !! Do not change !!
Calibration of f-reference: current A81 pre-adjusted !! Do not change !!
Reset input performance A86 0
PID-controller: P-gain A90 1.0
PID-controller: I-gain A91 1.0 s
PID-controller: D-gain A92 1.0
PID-controller: selection A94 0
PID-controller. reference A95 0
PID-controller: internal reference A96 0 %
Auto-Tuning A97 0
Motor data selection A98 0
Input phase supervision A99 0
Setting for input 1 C0 18
Setting for input 2 C1 16
Setting for input 3 C2 5
Setting for input 4 C3 11
Setting for input 5 C4 9
Setting for input 6 C5 2
Setting for input 7 C6 1
Setting for input 8 C7 0
Setting for output terminal 11 C10 0
Setting for output terminal 12 C11 1
Inputs 1-4: Inversion C20 08
Outputs 11,12 & relay: inversion C21 04
SX - Operating- & Projecting instruction - 8 074 667.02/02 - appendix A2