63
English
Belt 1: Engine - blade axle
• Remove the small belt (blade axle-Axelero
TM
)
• Unfasten the guide bolts (3 & 4).
• Undo the 4 bolts on the motor (5, 6, 7, 8) (M10 slw. 17).
• Move the motor block in order to release the tension on the belt
and undo the belt from the belt pulley.
• Install the new belt (order number BA 552 221 200) nd tension
it correctly. Be aware of the alignment of the motor block! Read
“11.4.5 Tightening the V-belt (Tighten belt)” on page 61
11.4.7 Checking the tension of the drive chain for the feed roller
• Remove the chain guard.
(read “11.2.2 Removing the chain guard” on
page 42)
• Check the tension of the chain
• If the chain is too slack, slacken the bolts (1 &
2) (M8 slw13).
• Tension the chain by tightening the nut (3) on
the threaded rod (M6 slw10)
Caution:
The tension on the chain must not be excessive.
• When the chain tension has been adjusted to the correct value, tighten bolts (1 & 2) (M8 slw13).
• Refit the chain guard (read”11.2.2 Removing the chain guard” on page 42)
11.4.8 Checking and adjusting the tracks for correct tension (Cross Country model)
A. Checking for correct tension :
• Lift the track somewhere in the middle between the drive sprocket and the tensioner.
• If you can lift it for about 1 cm from the tensioner, track tension is OK.
• If not, the track needs retensioning.
