45
English
In order to dismantle the lower sieve, the beta pin (1) must be released and the pin (2) removed
from the sieve.
Caution:
Make sure that the sieve is closed correctly and cannot fall open voluntarily. A
sieve that opens during work can cause considerable damage to the machine
and could pose a hazard for the operator and any bystanders.
• When closing, you must ensure that the hooks are placed in the correct position. When moving
the black lever, there must be sufficient tension on the hooks. If this is not the case, the hooks
should be adjusted.
• Use an SLW 13 wrench to undo the locking nut on the threaded end of both hooks.
• Undo the nuts by a few turns (clockwise) and then both hooks must be turned one rotation in
order to test the tension on the lever. If this is insufficient, the hooks must be progressively
turned until the tension is adequate. Then tighten the locking nuts securely.
• If it seems, when changing the sieve, that there is too much tension on the lever, the hooks
must also be adjusted (undo, anti-clockwise)
