English
73
TACHOMETER METER MODE
• Current engine speed is displayed in revolutions per minute (RPM) in increments of 20
RPM. The RPM icon stays on to indicate the meter is in Tachometer Mode.
• RPMs up to 9999 are displayed on the four large digits. If RMPs exceed 10000 the smaller
far right hand digit is also used.
• Meters automatically switch from Tachometer Mode to Usage Mode when the engine is
stopped and RPMs drop to zero.
MAINTENANCE ALERT ICONS
• The meter is programmed based on the recommended maintenance schedule of your en
-
gine and implement manufacturers. Check your Owner’s Manual(s) for additional detailed
maintenance information. A table is provided on the next page to record your maintenance
events.
• Maintenance Alert Icons flash when servicing is due, regardless of the mode the meter
is in, Usage or Tachometer. After maintenance is completed, reset the flashing icons by
PRESSING and HOLDING the Mode Button until the icon clears (takes approximately four
(4) seconds).
• FIRST ALERT: Servicing your new engine after the initial break-in is crucial. When a new
engine has been broken-in ALL ICONS FLASH on the meter. Perform the maintenance
specified in your Owner’s Manual.
• The Oil Can Icon indicates servicing is required on the crank case oil. The Wrench Icon
indicates general maintenance is required as prescribed in the Owner’s Manual.
• The Filter Icon is used in conjunction with arrows pointing to “AIR”,”OIL”, and/or “PRE”
printed on the meter label to indicate servicing is required on the air filter, oil filter or
air pre-cleaner. The arrows may point to other engine or implement maintenance events
printed on the label.
• Following the manufacturer’s recommended maintenance schedule extends the perfor
-
mance,
longevity and environmental compliance of the engine.
