English
28
Transport to the work site
• There are two speed settings on the snowbob. The
‘fast’ setting should be chosen when moving to
and from the work site. Hold the speed lever to the
left and, at the same time, depress the dead man’s
handle. The speed lever will move upwards into the
transport setting.
Speed:
o
work mode: -1.5 km/h < 0 > +1.5 km/h
o
transport mode: -5 km/h < 0 > +5 km/h
Caution:
If the dead man’s handle is released, the speed lever will set itself back into the
right hand setting (slow speed). If you wish to continue moving, you must reset
the speed before pressing the dead man’s handle downwards.
• Make sure the cutter head is raised for transport. You can raise the cutter head in two
ways:
o Press the small joystick on the left of the dashboard
downwards.
o Depress the red button on the back of the large joy-
stick. When you release the red button, the cutter
head stays in position.
• You set speed via the large joystick in the centre of the dashboard. If the joystick is moved
forward, the Snowbob will move faster. The Snowbob will go backwards if you pull the
joystick towards you.
• The direction in which you wish to move is set using the large joystick in the centre of the
dashboard. If you wish to go left, move the joystick towards the left. If you wish to go right,
move the joystick towards the right.
Caution:
Turning directions are reversed when you move backwards. If you then push the
joystick left, the machine will go right.
