Eliet KS300 PRO, Manual

Page: 23 / 48

English
23
depth).
There are 6 settings. The first two settings are for disengaging the clutch, the others are for
setting the blade. The blade rises or falls by about 2 cm per setting.
Now compare the desired cutting depth with the actual cutting depth.
Set the depth regulation lever in its highest setting.
Pull the Beta pin (2) out and take the screw (3) out of the holder.
Turn the screw to the left to raise the blade or to the right to lower the blade. (A 1 cm movement
of the screw gives approximately 2 cm movement of the blade).
Now place the screw back in the holder and replace the Beta pin.
9.5.3 Setting the angle of the blade
Follow the instructions below if you would like slanting edges on your lawn.
• Pull the depth regulation lever back as far as it will go (disconnect).
• Place the angle setting lever in the desired position by pulling the lever backwards and turning
Caution:
The blade must only be set if the engine is switched off