Eliet DZC450, Manual

Page: 81 / 108

81
English
IV. Friction surfaces
Friction surfaces include all machine parts that are subject to wear from lateral friction with
other parts. Here, too, it is important to apply a film of lubricant between the rubbing parts
that will reduce movement resistance and minimise wear.
These surfaces in the machine include:
1. Cable guides
2. Locking pin for transport mode
3. Fork for movement of seed slider
4. Height adjustment handlebars
5. Locking pin depth adjustment
• Proper functioning of the control levers is crucial and regular lubrication of the cables is
therefore of vital importance.
• In particular during dryer periods, operating the machine will produce a lot of dust This set-
tles everywhere, including on the cables.
• Prior to lubricating, the cables must be cleaned. KLEENSPRAY is again an ideal aid in this
regard.
• Spray the cleaner into the cable guide and at the same time move the cable back and forth in
the guide so that the fluid spreads.
• Use compressed air to clean the cable guide of both cleaner and dirt.
• Repeat this procedure until the guides are completely clean.
5
2 3
1
4