ELGO Electronic P40-000 Series, Operating Manual

Page: 16 / 64

Handling & Operating Modes
- 16 -
7.1.2 Single Operation
This mode allows moving all active axes simultaneously after entering the desired target values and confirmation
by the START key.
Figure 6: Single Operation
Displays the actual position of the respective axis
Incremental positioning:

target value is an absolute position

target value is an incremental po

target value is an incremental position −
Displays the target value of the respective axis
Input field for quantity
Referencing of the respective axis: Use the cursor to select the
desired axis and press the F2 button longer than 2 seconds.
NOTE!
Incremental Positioning:
Select corresponding axis with the cursor and change positioning mode by pressing the E
ENTER nter-Key (see chapter

9.3 “Parameter Axis: “)
Referencing:
see chapters:

7.2 “Referencing an Axis”,

9.3 “Parameter Axis: “
and table in section

14.1 “Parameter Axis: Distances”
3
4
2
1
1
2
F1
3
F3
4
F2