Fault
Possible cause
Remedy
• Radio programming mode
• Faulty connection
• Check connection
does not start
• Drive not connected to mains
• Check mains voltage
• Time frame already expired (5 min)
• Interrupt mains voltage briefly
• Thermostat has triggered
• Allow drive to cool down
• Radio transmitter has no battery
• Check transmitter (LED must be illuminated)
• Radio transmitter not in
• UP/DOWN button pressed too late.
• Restart radio programming mode
programming mode
Note time frame (1 sec.)
• Sender ist bereits eingelernt
• Push STOP button
• Drive does not react to double
• Time frame already run out when mains
• Interrupt power supply briefly
button-pressing on radio
power returns (5 Min.)
transmitter
• Drive not connected to mains
• Check mains connection
• Transmitter is not programmed
• Program the transmitter
• Drive is no longer reacting
• Thermostat has triggered
• Allow drive to cool down
• Drive stops during travel
• Thermostat has triggered
• Allow drive to cool down
einer
Fahrbewegung
• Drive does not accept
• Random travel
• Delete end positions
programmed end positions
• Travel to end position/limit stop too short Re-program end positions
• Drive has to travel to short STOP
Troubleshooting
Changing/Deleting the end positions
Notes on troubleshooting
Changing/Deleting the end positions using the radio
transmitter
2. Move the blind to the centre position.
Auto
VarioTec
Reset
Pos Pos
Auto
VarioTec
Pos
Pos
Reset
Reset
Pos
P
VarioTec-868
Auto
Pos
Reset
VarioTec-868
P
Pos Pos
3
2
1
3
2
1
Changing / Deleting the end positions using the
assembly cable
Auto
VarioTec
Reset
Pos Pos
Auto
VarioTec
Pos
Pos
Reset
Reset
Pos
P
VarioTec-868
Auto
Pos
Reset
VarioTec-868
P
Pos Pos
approx.
5 sec.
1. Switch on mains.
2. Move the blind to an centre position.
The drive is ready for the program to be deleted.
approx.
5 sec.
3. Press both buttons on the assembly cable
simultaneously
.
The drive travels up and down briefly after approx. 5 seconds.
Deletion of the end positions is complete.
You can now re-program the end positions.
Blau (Neutralleiter)
Schwarz
Braun
Grün-gelb
elero
%OXHQHXWUDOZLUH
%ODFN
%URZQ
*UHHQ\HOORZ
Mains
1. Switch off/on mains.
After the mains has been switched off for a short time, the
drive is ready to be deleted for approx. 5 minutes.
3. Press
UP
and
DOWN
button
simultaneously
.
The drive travels up and down briefly after approx. 5 seconds.
Deletion of the end positions is complete.
You can now re-program the end positions.
Deletion of individual transmitters
→ see instructions for the control unit
Deletion of all transmitters
→ see instructions for the control unit
3
2
1
3
2
1
Blau (Neutralleiter)
(1)
Schwarz
(2)
Braun
(3)
Grün-gelb
elero
%OXHQHXWUDOZLUH
%ODFN
%URZQ
*UHHQ\HOORZ
Mains
6 | EN
