EN | 3
Programming the transmitter/
Programming further transmitters
Programming the transmitter
Condition:
The drive is in radio mode.
The end positions must have been programmed.
If the end positions have not been programmed,
remove the blind from the shaft.
When the mains has been switched off for a short time,
the drive is ready to be programmed for 5 minutes.
1.
Switch off/on mains.
STOP
3.
Press the
UP
button
immediately
after the start of upward
travel.
4.
Press the
DOWN
button
immediately
after the start of
downward travel.
The drive will stop.
The transmitter is now programmed.
Auto
VarioTec
Reset
Pos Pos
Auto
VarioTec
Pos
Pos
Reset
Reset
Pos
P
VarioTec-868
Auto
Pos
Reset
VarioTec-868
P
Pos Pos
Auto
VarioTec
Reset
Pos Pos
Auto
VarioTec
Pos
Pos
Reset
Reset
Pos
P
VarioTec-868
Auto
Pos
Reset
VarioTec-868
P
Pos Pos
2.
Press programming switch
P
on your transmitter.
The drive runs up and down for 2 minutes.
STOP
Stopping the radio programming mode
→ see transmitter instructions
Programming procedure for other transmitters
Programming procedure possible for max. 16 transmitters.
In order to program further transmitters, start with the new
transmitter at 1
or
STOP
STOP
3.
Press the
UP
button
immediately
after the start of upward
travel.
4.
Press the
DOWN
button
immediately
after the start of
downward travel.
The drive will stop.
The transmitter is now programmed.
Auto
VarioTec
Reset
Pos Pos
Auto
VarioTec
Pos
Pos
Reset
Reset
Pos
P
VarioTec-868
Auto
Pos
Reset
VarioTec-868
P
Pos Pos
Auto
VarioTec
Reset
Pos Pos
Auto
VarioTec
Pos
Pos
Reset
Reset
Pos
P
VarioTec-868
Auto
Pos
Reset
VarioTec-868
P
Pos Pos
2.
Press
simultaneously:
UP
and
DOWN
buttons and programming button
P
on the
programmed transmitter for min. 3 seconds.
The drive runs up and down for 2 minutes.
Auto
VarioTec
Reset
Pos Pos
Auto
VarioTec
Pos
Pos
Reset
Reset
Pos
P
VarioTec-868
Auto
Pos
Reset
VarioTec-868
P
Pos Pos
min. 3 sec.
Programmed transmitter
New transmitter
New transmitter
+
1.
Switch off/on mains
