elero MultiTec Touch-868, Operating Instructions Manual, Page: 20 / 27

38 | EN Ⓒ elero GmbH
Ⓒ
elero GmbH EN | 39
1. Where electrical receivers have already been installed,
interrupt the power supply and switch it on again after a
few seconds. The receiver is now in programming mode
for about 5 minutes.
2. Push the function button P in the menu Teach trans-
mitter until the transmission status display is lit green.
The curtain moves up and down for approximately two
minutes, showing that the receiver is in programming
mode.
Visualisation binding orange
3. Press the UP button as soon as the curtain starts moving
in the upwards direction (within 1 second at the most).
The transmission status indicator is lit briefly. The curtain
stops, starts moving again and then moves DOWN.
4. Press the DOWN button as soon as the curtain starts
moving in the downwards direction (within 1 second at
the most). The transmission status indicator is lit briefly.
The curtain stops. The transmitter channel has been
programmed.
Important:
Programming will have to be repeated if the curtain does
not stop. Programming in the wall transmitter (signalled
by orange background) can be terminated by pushing the
touch field Cancel or by pushing the STOP button for 6 sec-
onds (square symbol).
4.1 Program further transmitters into a channel.
Multiple receivers connected to the same supply are all
simultaneously ready for programming for approximately 5
minutes after connection to the mains.
If the P button on the MultiTec Touch-868 /-915 is now
pressed, all receivers start the programming mode simul-
taneously (travelling up or down). An offset is created be-
tween the receivers by randomly different pauses between
the ascents/descents. The longer programming is delayed,
the greater the offset will be.
You can stop the short opening and closing movements by
briefly pressing the STOP button on a transmitter which has
already been programmed. The programming mode in the
receiver is interrupted.
The transmitter can now be assigned without having to
disconnect individual receivers. If the curtain moves in the
wrong direction, delete the transmitter and program it in the
receiver again (→ see Deleting transmitters).
To program additional transmitters to one receiver:
1. Press the UP , DOWN and the programming button P
(back of device) simultaneously (for 3 sec.) on a transmit-
ter, which has already been programmed to the receiver.
The status indicator is lit briefly. The receiver is now
ready for programming and briefly moves down.
2. Press the programming button P on the transmitter to
be programmed until the status display lights briefly. The
receiver is now in programming mode (movements up
and down).