Programming
GB-33
Programming
GB-34
FUNCTION (only when the operating device is disconnected, only for
qualified electricians)
EXTERNAL ON/OFF/SWITCH, ALARM SIGNAL ON/OFF
(Processing external signals, processing alarm signals)
FUNCTION (only when the operating device is disconnected, only for
qualified electricians)
ROLLER SHUTTER/BLIND, DRIVE CONTROLLER/GROUP CONTROLLER,
RUNNING TIME
(Selection of shutter/blind, selection of the drive controller/ group
controller, running time of the roller shutter/blind)
+
+/-
OK
See
next page
FUNCTION
ROLLER
SHUTTER/
DRIVE
CONTROLLER/
GROUP
CONTROLLER
RUNNING
OK
OK
OK
OK
+/–
+/–
+/–
1. Press the
MENU
button.
2. To select the FUNCTION menu, press the
+
button until
FUNCTION appears.
3. Confirm by pressing
OK
. ROLLER SHUTTER/BLIND will appear.
4. You can select either roller shutter or blind using the
+/-
button.
5. Confirm by pressing
OK
. DRIVE CONROL DEVICE/GROUP
CONTROLLER will appear.
6. You can select the control device required using the
+/-
button
(DRIVE CONROL DEVICE/GROUP CONTROLLER).
7. Confirm by pressing
OK
. RUNNING TIME will appear.
8. You can set the required running time using the
+/-
button.
(Default setting: 120 seconds).
9. Confirm by pressing
OK
.
The RUNNING TIME function has now been set.
Please read on for further programming options using the
FUNCTION menu.
GB
K
See
previous page
EXTERNAL ON
EXTERNAL OFF
EXTERNAL
➞
SWITCH
Drive controller ?
ALARM SIGNAL ON
ALARM SIGNAL OFF
See
next page
OK
+/–
OK
OK
+/–
OK
OK
OK
+/–
+/–
You have confirmed the RUNNING TIME function.
EXTERNAL ON will appear.
(EXTERNAL ON/ OFF/ SWITCH describes the external control
signals. Default setting is EXTERNAL SWITCH)
1. You can select the required setting for the control inputs using
the
+/-
button.
2. Confirm your selection by pressing
OK
.
Note:
The following dialog window will only be displayed if you
have selected DRIVE CONTROLLER.
ALARM SIGNAL ON will appear. (The default setting is ALARM
SIGNAL ON.).
3. You can switch the ALARM SIGNAL to ON or OFF using the
+/-
button.
4. Confirm by pressing
OK
.
The function ALARM SIGNAL ON/OFF has now been set.
Please read on for further programming options using the
FUNCTION menu.
