4. Measuring, Storage and Data Processing in DIRECT or APPL-BATCH mode
© ElektroPhysik
MiniTest 2500 - MiniTest 4500
16 of 73
Status after Switch on
Press ON key while holding the probe in the air. The gauge automatically resumes the mode
selected previously (either
‘DIRECT-’ or ‘APPL-BATCH’).
If start-up proceeds in
‘APPL-BATCH mode’, the gauge will select the ‘APPL-BATCH’ memory
previously selected and the last ready (if available) will be displayed.
Calibration values and statistics are stored in memory.
Measurement can start directly in
‘DIRECT mode’ or be continued in ‘APPL-BATCH’ mode
provided the gauge works with a valid calibration.
If all data have been deleted, only the measuring unit, e.g. < µm > along with the measuring mode
FERROUS or NONFERROUS will be shown depending on the sensor connected to the gauge.
Note:
If you switch from
‘DIRECT’ mode to ‘APPL-BATCH’ mode, all statistical data will be kept in
memory.
The statistical data will not be stored if you change the probe.
When pressing the APPL-BATCH key, the pair of numbers of the last active APPL-BATCH
memory will be shown on the display.
The gauges switches off automatically according to the selected switch-off-time after the last
measurement (see also section 11.1 initial settings).