APPENDIX A: MACHINES
90
SY BITS
TUNE
(Tune) offsets the incoming note value. This parameter is bipolar. A setting of 0 leaves the pitch
unchanged.
DET
(Osc 2 Detune) sets the tuning of oscillator 2 relative to oscillator 1.
BAL
(Balance) sets the level of the oscillators and the noise. At value 0, it produces only noise. From
1–64 oscillator 1 fades in. Between 64–127 the second oscillator fades in and the noise is faded out.
DEC
(Decay) sets the length of the decay phase of the machines internal amp envelope.
WAVE
(Wave) sets the waveform of the oscillators. The parameter snaps to the pure waveforms. A
value above 64 narrows the duty cycle of the square waveform. Setting
WAVE
to 96, and then modu-
late it with an LFO with
DEPTH
set to 32 will create full range pulse width modulation.
SRR
(Sample Rate Reduction) sets the amount of sample rate reduction.
BR
(Bit Reduction) sets the bit rate. The parameter range is from 16 bits to 2 bits.
OVER
(Overdrive) sets the gain amount into the digital overdrive.
SY TONE
TUNE
(Tune) offsets the incoming note value. This parameter is bipolar. A setting of 0 leaves the pitch
unchanged.
RATIO
(Ratio) sets ratio between the operators.
PNCH
(Punch) adds a compressor-like envelope, which accentuates and distorts the sound.
DEC
(Decay) sets the length of the decay phase of the machines internal amp envelope.
FDBK
(Feedback) sets the amount of feedback.
MOD
(Modulation) sets the amount of modulation.
MENV
(Modulation Envelope) sets the decay and depth of the modulation envelope.
OVER
(Overdrive) sets the gain amount into the digital overdrive.
SY CHORD
