Electromotive xdi, Installation Manual & Users Manual

Page: 30 / 36

XDI Manual Version 1.8 Page 30

2017 Electromotive, Inc.
Insertion:
To insert the pins into the AMP 23-pin connector, lift the two side tabs on the red part of the connector. Gently
pull the red section out until it raises approximately ¼ inch and is loose. It is recommended that you do not
remove the red insert section completely. Look at the wire side of the connector and locate the four pin
locations for the DFU harness wires to be inserted. Push the pins into the connector. This may require the use
of needle-nose pliers to insert the pin(s) fully. If you make a mistake, you can extract the pin from the
connector by pulling the wire. You must make sure the red part of the connector is in the “up” or “loose”
position. Push the red part of the connector back into the connector when you are done. Make sure the pins you
inserted are all the way to the top of the connector. If you need to push the pin further, repeat the insertion
steps.
Removal:
Begin by lifting the two side tabs on the red part of the connector. Gently pull the red section out until it raises
¼ inch and is loose. Once the red section of the connector is loose, simply pull the wire you wish to remove.
Once the wire is removed, push the red section back into the connector.