Electrolux IC44819 FLF, Service Manual, Page: 171 / 290

5
15
Bp4
Service
Manual
DIaMMS kit
04106016/GB
43-09
Before any intervention it is essential to cut off all supply of the machine
(electricity, steam, water, gas, compressed air...).
Repair
Checking
- Check the wiring.
- Ensure contact between the two humidity sensors comb and check that the value
«Moisture» in «Service option» varies, otherwise the sensors comb are faulty.
Replacing
- Remove the reception vat on the feeding table (on FLF)
- Disconnect the wires.
- Remove the 2 sensors comb from the separator bar.
- Fit the new sensors comb and connect them on their respective terminals.
- Perform an adjustment as described above.
DIaMMS settings
In order to have a working correctly of DIAMMS system after replacing the control display, it is
necessary to set the P1 and P2 potentiometer and to check the parameter «Value of Length»
«Service Option» access
The machine has been set in the factory to specific values of heating, folding, temperature,
ironing speed, operating language, etc. These values and specifications can be set in the
«Service Option» menu.
The parameters must always correspond to the specific type of machine.
• Remove the left side frame of the machine.
• Press on the push-button «BP4» on the board n°1 of the control panel using an insulated
tool.
board n°1
board n°2
control panel