Electrolux ESI6180U, Manual

Page: 23 / 28

Page
23 DW 107
With the door CLOSED:
Once the test procedure has been started:
The component will be tested for a maximum time (Time-out), as shown in the table.
To proceed to the subsequent component, press
Sw1
until the test procedure is completed.
On completion of the test procedure, the display shows [
C d 6
] to indicate that the last component has
been tested.
Press
Sw1
again
The 3 Digits on the control panel indicate [
8 8 8
] and all the LEDs light for
5sec
; the buzzer sounds.
After
5
sec the appliance returns to the beginning of the test, and the display shows the software
version E.g. (Refer Page 22 Software Version -
a
).
To repeat the test, Press
Sw1
again; it restarts from section –
b
Page 22) and so on.
Press
Sw0
to exit the test routine
FUNCTION DIAGNOSTICS CYCLE
The purpose of the Function Diagnostics cycle is to provide the Service Engineer with a rapid test for
the washing programme sub-phases by passing through each phase of the cycle sequentially.
In this way it is possible to check the functions which are carried out during the washing cycle by
performing the sub-phases manually in sequence. This routine can be adapted to perform only those
functions that are of interest, excluding the remaining functions.
Each cycle phase consists of a series of sub-phases for the functions included in the programme.
Cycle phases in a complete washing programme
Definition of the sub-phases
Note:- This model does not
have a Fan.