Electrolux ESI6180U, Manual

Page: 21 / 28

Page
21 DW 107
OPTIONS FOR IMPROVING WASHING PERFORMANCE
In cases in which the user is dissatisfied with the wash performance, a procedure has been developed
(exclusively for Service Engineers) that makes it possible to utilise a series of supplementary options
which improve the wash performance.
These options are memorised in the electronic control system and consist of three functions, each
identified by a specific code which allows them to be used when necessary.
DISPLAY
SUPPLEMENTARY OPTIONS
[- - 0] [- - 1] [- - 2] [- - 3]
Supplementary water fill (+ 24%) in all fill phases. Impulse
(
puls
) wash replaced by
ctrl
wash
(
Constant motor speed 2800rpm)
--
YES
--
YES
Supplementary cold rinse (
+ 1
)
YES YES
SETTING THE WASHING PARAMETERS.
With the door Closed and the Dishwasher switched Off (Programme Selection mode)
1.
Press and hold down.
Sw3
&
Sw4
simultaneously
2
. Press
Sw0
to switch the dishwasher on.
3
. Hold down
Sw3
&
Sw4
for about
5sec
after which the Buzzer will sound
The 3 digits on the display will show:
•
Dgt_1 & Dgt_2 [
- -
] two segments lit.
•
Dgt_3 = [
0
] one number [ 0, 1, 2, 3 ] identifying the supplementary options.
Example [
- - 0
] - no options (standard setting).
•
To switch from one option to the next Press
Sw1
repeatedly [ 0, 1, 2, 3 …0..].
•
To confirm selection of the options Press
Sw2
.
•
Press
Sw0
to exit the set-up procedure.
COMPONENT DIAGNOSTICS TEST
The diagnostics procedure is divided into two parts:
Part 1
provides the Service Engineer with information regarding the status of the dishwasher.
Part 2
makes it possible to check the electrical components for correct operation.
SELECTING THE COMPONENT DIAGNOSTICS ROUTINE
With the door OPEN and the dishwasher switched OFF (Programme selection mode):
1. Press and hold down
Sw1
&
Sw4
2. Press
Sw0
to switch the dishwasher on.
After about 5 seconds, the 3 Digits and all the LEDs light for
5 seconds
and the buzzer sounds
(sequence_B).
After
5 seconds
, the display shows:
a
) The SOFTWARE VERSION is displayed as follows
DGT_1 [ ] off
DGT_2 [
.
] number [ 0 ... 9 ]
DGT_3 [
.
] letter [ A, b, C, d, ...]
Example: [.
3 A
] = Software version of control board.
*
Press
Sw1
repeatedly: the three digits will display the following information: