Electrolux ESI6180U, Manual

Page: 25 / 28

Page
25 DW 107
7.
To cancel the diagnostics cycle currently being performed, press
Sw5
and hold down for
5
seconds.
At the end of the cycle, the display shows [
- - -
] for
5 seconds
to indicate the end of the programme
and the system exits the diagnostics cycle automatically.
After a further
5
seconds, the display shows the last programme performed (e.g. [
P . 3
]).
Press
Sw0
to switch the appliance off.
Note:
The safety devices are operative during the diagnostics cycle; in case of a malfunction, the
relative ALARM code is shown in the DISPLAY.
TEST CYCLE
The test cycle is a special abbreviated washing programme for use by Service Engineers only, who
can test all the functions which comprise a traditional cycle.
This test is designed to action all the actuators (fill solenoid valve, regeneration solenoid valve, reset
solenoid valve, washing and drain motor, heating element, and detergent dispenser) in a cycle in
which the operating times for each are shortened.
Drai
n &
Reset
Fill + Disp
en
. 1
0"
Was
h
Drai
n &
Reset
Fill & Disp
. 10"
R
egen
. 2'
Fill & Drain
Drai
n &
Reset
Fill & Wash
Drai
n &
Reset
Fill Wash 52
ºC
Disp.
1
5”
Drai
n &
Reset
Modes and Times
Water fill level at motor target speed 2300rpm
The washing times are reduced.
Washing at a constant motor speed of 2800rpm
The temperature of the water in the hot phase is stabilised (target: 52ºC).
Regeneration is performed in the first hot phase (irrespective of the regeneration level selected).
The test cycle is not included in the regeneration counters.
The overall time for the cycle is about 40 - 45 minutes.