Setting
Implementation
Water hardness
1)
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness and Start/Pause buttons and hold
down for approx. 5 seconds.
3. Press the Start/Pause button until you set desired level:
- low conductivity <300
μ
S/cm
- medium conductivity 300-600
μ
S/cm
- high conductivity >600
μ
S/cm
4. To memorize setting press simultaneously the Dryness and Start/
Pause buttons or turn knob to
off
position
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of
the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the
water.
SERVICE
If there are technical faults, first check if you
can remedy the problem yourself with the
help of the operating instructions - see
chapter
What to do if….
If you cannot remedy the problem on your
own, get in touch with the Customer Care
Department or one of our service partners.
To assist you quickly, these data are neces-
sary:
– Model description
– Product number (PNC)
– Serial number (S No. is on rating plate
stuck to the product - to find it see chapter
Product description
))
– Type of failure
– Any error messages shown by the dis-
play.
So that you have the necessary reference
numbers from your appliance at hand, we
recommend that you write them in here:
Model descrip-
tion:
........................................
PNC:
........................................
S No:
........................................
14
electrolux
