Electrolux CEI30EF5GB, Service Manual

Page: 39 / 47

Page 39
Luxury Glide Oven Rack Removal & Maintenance
To remove and replace the Luxury Glide oven
racks open the oven door completely. Locate
the spring loaded plunger below the rack
bearing channel on each side of the rack.
(Photo A).
Using your thumbs push both plungers in at the
same time to unlock the rack. (Photo B).
Pull the rack assembly forward to remove it
from the oven.
Photo A Photo B
The Luxury Glide Oven Racks have no serviceable parts and should be replaced as a complete
assembly if defective. The ball bearing glide assemblies on the oven racks should be lubricated
annually or more often as needed. Use only the approved water based graphite lubricant.
NEVER use grease or oil of any kind to lubricate the racks or bearings. Approved lubricant is
available through your authorized Electrolux parts supplier under part number 5304468694. This
lubricant should also be used on the rack switch sensor rod assembly
To lubricate the bearings remove the racks as
described in the owners manual. Place the rack on
a protected work surface and slide the rack to the
fully extended position to expose the ball bearing
assembly inside the track. Using the dispenser tip
of the lubricant bottle place a few drops of lubricant
on the top and bottom bearing carriers in the areas
indicated by the arrows in photo C. The lubricant
will be spread to all of the ball bearings as the rack
is operated. Use the lubricant sparingly, a few drops
is all that is necessary.
Repeat this process for each bearing assembly. There are two bearing assemblies on each side
of the rack, one on the inside as seen in the photo and one on the outside. Also lubricate the rack
release plunger mechanism at all friction points as needed.
Lubricate Here
Photo C