Installation manual
7
3 Introduction
The Jetsave system is designed to be connected directly to the washer extractor using two multi pin connectors.
The Jetsave controls the amount of product dispensed and product delays if required.
The Jetsave system connected and supplied from the washer extractor 230V, 50/60Hz 0.1A (Max).
The Jetsave is an integrated water flush chemical dispensing system.
Power
Data
fig.X01323A
• The washer extractor is provided with AMP Style power and interface connectors so no external power source is
needed for the pumps.
• The Jetsave system is for indoor use only.
• Ensure that the unit can be mounted in an accessible position above the height of the required discharge location.
Note!
Above shoulder height would require steps or platform.
• The Jetsave control unit can be installed within 3 m from the washer extractor (with possibility to extend the dis-
tance up to 15 m using optional power and the data cable) and close to product containers and at a convenient
height for servicing, about 1–1.5 m.
• The input tubing from the chemical container to the Jetsave shall not be more than 2 m.
• The tubes must not be twisted and shall hang freely without any sharp bends. Longer tubes requires maintenance
more often.
• The Jetsave 2-5 pumps can be daisy chained to create up to 15 pumps with 3 Jetsave units. (6-10 pumps can not
be daisy chained).
• Max. 3 pumps can be ordered from the washer extractor and each pump will be run in the queue.
Jetsave PNC’s
Description
988930001
Complete kit with 2 pumps, 550 ml/min
988930002
Complete kit with 3 pumps, 550 ml/min
988930003
Complete kit with 4 pumps, 550 ml/min
988930004
Complete kit with 5 pumps, 550 ml/min
988930005
Complete kit with 6 pumps, 550 ml/min
988930006
Complete kit with 8 pumps, 550 ml/min
988930007
Complete kit with 10 pumps, 550 ml/min
