Electra Monoblock 7, Service Manual

Page: 165 / 187

English 6
A standard kit (Figure 8), supplied with the air conditioner for suporting the outdoor unit, makes it
possible to mount it either from a window sill (Figure 6) or on the wall (Figure 7), refer to Figure 8 for
reference numbers in the following steps.
INSTALLATION OF OUTDOOR UNIT (See Figure 6,7,8)
1. Install the 4 spacing studs (1) at the back of the unit to assre undisturbed air flow to the unit.
2. For window mounting, refer to Figure 6. Place the support bracket (3) on the window frame, drill four holes in the
window frame and mount the support securely with four screws.
3. Attach the two lower snap-hooks (5) into the side holes of the unit.
4. Lift the unit up, pass it over the window and hang it inserting the hanging strip in the apposite grocve.
5. Verify that the unit is well supported, stable and level. Suspension Straps (2) can be used to level the unit.
6. For wall mounting, refer to Figure 7, place support bracket (3) against the wall, drill four holes in the wall and
fasten with the four screws; verify that support is level.
Figure 6. Suspending outdoor unit from window sill Figure 7. Suspending outdoor unit from wall
For all models up to 3.1 KW and 4.1 KW
3.1 KW (R407C) Model 4.1 KW (R22/R410A) Model
3.1 KW (R410A)
1. Spacing stud (x4)
2. Suspension strap
3. Supp rt bracket
4. Snap-hook (x2)
5. Bolt (x4)
6. Washer (x4)
7. Nut (x4)
8. Suspending bracket (for
models 3.1KW / R407C)
o
Figure 8. Outdoor unit supporting kit
1
8
1
6
7
5
2
4
3