Electia CTC 1132, User Manual

Page: 30 / 128

CTC-1132 868AM 2007.07.18 28
condition of that sensor will not be
checked.
)
If a sensor tampered or out-of-order
occurs, you can temporarily by-pass it
or permanently remove it.
Arming with Door Opened
z
While you arm the system, if any door was
detected to be open, the Control Panel will
also sound a ding-dong warning sound to
indicate arming is prohibited. The
message “
Fault DSP ” is displayed in the
middle of the top display row and
alternates at 2-second intervals with the
sensor name that is being triggered.
z
At this moment, you can close the opened
door, after which the fault display will be
cleared automatically and the screen
returns to
“ Alarm off ”. You then can arm
the system again.
z
However, if you want to put the system
into Arm mode with the opened door, it is
still possible by following the Steps
described above to execute
” Forced
Arming ”.
IV. Disarm (Alarm off) mode
Disarming the system
To disarm the system
If the system is in either the Away Arm mode or
Home Arm mode (Alarm ON), enter your pin
Code and press
“ OK ”. If the PIN code is
correct, the Control Panel will sound 2 short
beeps and return to Disarmed mode. The
screen will show.
A l a r m O f f
0 6 : 4 3 0 1 J a n
< < N N O O T T E E > >
)
When the system is Home Armed,
pressing the “ DISARM ” button on the
Remote Controller will disarm the
system.
)
When the system is Away Armed,
pressing the “ DISARM ” button on the
Remote Controller can disarm the
sytem when either an “
Entry ” device
has been triggered, or when the
“ Remote Controller Entry Enable ”
has been set to “ ON ”.
V. Home Arm Mode
The Home mode allows the home to be Armed
so that no one can get inside without first
Disarming the system, yet the person already
inside the house can move freely without self
triggering the alarm.
<
<
N
N
O
O
T
T
E
E
>
>
)
You can enter the HOME mode only
when the system is in DISARMED
mode.
1. Entering Home Mode:
Step 1. When the system is in Disarmed mode,
key in your Pin Code then press “ OK ”.
Step 2. Press “
T
“ to move the cursor down to
select “ Home Arm ”.
Step 3. Press “ OK ” and the screen will display.
T i m e T o E x i t
3 0 s e c
The defined EXIT Delay is displayed on the
second line, and is counting down. During the
EXIT Delay period, the exit sound plays, unless
it has been chosen to switch off.
Step 4. When the Exit Delay time is up, the
Control Panel will sound a long beep.
The “
Home ” will display on the screen
and the system is in Home Arm mode.
<
<
N
N
O
O
T
T
E
E
>
>
)
The system can also be armed by using
the Remote controller (Optional).
Step 5. Press “ OK ” and the screen will display.
H o m e
0 8 : 0 0 1 6 D e c
2. Stopping the Exit Delay
The Exit Delay can be stopped following the
steps described in “
Stopping the Exit Delay ”
in section II, “ Away Mode ”
3. Extend the Exit Delay
The Exit Delay can be extended following the
steps described in “
Extend the Exit Delay ” in