Eldom Matt M200, Instruction Manual

Page: 13 / 52

EN
•
13
FIG. 6.1 FIG. 6.2 FIG. 6.3
SLICER
• Install a blade of your choice in the slicer (C) : see fig. 6.1 .
• Place the whole unit in the body
(15)
:
see fig. 6.2
. Check whether the slicer
(B)
is locked.
• Insert the pusher (1) in the hopper: see fig. 6.3 .
• Place a bowl under the outlet of the slicer.
• Connect the appliance to the mains of the parameters compatible with those stated above and start it with
the button (14) : position "ON" .
• Put the ingredients one by one into the hopper and use the pusher (A) to slide them downwards to the
rotating blade (C) .
STORAGE
Unused grinding plates may be stored in the compartment (16) see fig. 1 .
The butchering set
(10, 11)
and the kebbe set
(12, 13)
may be put inside the
pusher (1) : see fig. 7 .
CLEANING AND MAINTENANCE
Disconnect the power supply when the unit is not in use or before cleaning
it. Clean the device right after its use. Before cleaning, dismantle the parts of
the appliance. Wash them in warm water with washing liquid, use a brush,
rinse under running water and wipe dry. Put a thin layer of edible oil on
the grinding plates and the knife to protect them against rust. Do not use
abrasive agents, cleaning powders, acetone, alcohol, etc., for cleaning. Do not
immerse the body in water and do not rinse it under running water. Clean the
body of the appliance with a damp cloth. The device cannot be immersed in
water or washed in a dishwasher.
The knife is an utility tool and should be replaced regularly. The knife is not covered by guarantee.
ENVIRONMENTAL PROTECTION
- the appliance is made of materials which can be recycled.
- it should be handed over to the applicable collection point for the recycling of electrical and electronic
equipment.
WARRANTY
- this appliance is designed for domestic use only.
- it cannot be used for professional purposes or for other than the intended use.
- improper use will nullify the guarantee.
FIG. 7