ELCOS- Parma- Italy - GB - CAM -684
3
Valid for firmware revisions higher than or equal to 1.24
With the running
engine the
generator set
instruments are
shown. In the
event of a fault,
instead of the
measurement,
the display
shows the
message of
the occurred
fault.
INSTRUMENTS
BRIEF INSTRUCTIONS
"
"
"
"
With battery charger type CBS
• THREE MAINS AND GEN-
ERATOR VOLTMETERS
up to 570V
• THREE MAINS/
30/5, 40/5,
GENERATOR
80/5, 100/5, 150/5, 200/5, 250/5, 300/5,
600/5, 800/5, 1000/5,
AMMETERS
1200/5, 1500/5, 2000/5, 2500/5, 3000/5, 4000/5.
• FREQUENCY METER
greater than 30 V~.
• WATTMETER
(Total and per phase)
• VARMETER
• VOLTAMMETER
• COSPHIMETER
(Per phase)
•
65535.
•
FAILURE
COUNTER
9999
•
8500 rpm.
•
• BATTERY CHARGER CURRENT
For three-phase voltages and nominal value
~.
• DELTA VOLTAGES
PHASE/PHASE
• STAR VOLTAGES
Compatible with the amperemetric transformer type
50/5, 60/5,
400/5, 500/5,
Maximum reading of 4000A
or 110% of the full-scale current of the chosen transformer.
From 0Hz to 85Hz for alternating voltages with amplitude
• KILOWATT-HOUR
(Total)
• PARTIAL HOUR-METER With four digits and a maximum reading of 9999 (hours and minutes). (The
hours indicated are zeroset the next time the genset is started up.)
• TOTAL HOUR-METER
Displays five digits and a maximum reading of 59999 (hours and minutes).
STARTING COUNTER
Displays the number of occurred startings up to
STARTING
Displays the number of failure startings up to
TACHOMETER
Displays the number of engine revs up to
BATTERY VOLTMETER
• FUEL LEVEL GAUGE
Displays the percentage of fuel present in the tank
• WATER OR OIL
THERMOMETER
Displays the water and oil temperature of the engine up to 140°C
• OIL PRESSURE GAUGE Displays the oil pressure of the engine up to 9 bar
C
MODEM
ENGINE
Equipped with control unit
for the electronic control of
the injection system
10m max
500m max
RS232/
RS485
RS232/
RS485
MODEM GSM
ELCOS
CAN Bus
RS232
RS485
I/0
EXTENSION
REMOTE
PANEL
I/0
EXTENSION
MOD BUS
" "
MASTER
" "
MOD BUS
