59
Safety sheet
per EU regulation Nr. 453/2010
Antifrogen SOL HT
8.2
Limitation and supervision of exposure
General
safety
measures
Observe the usual precautions for handling/working with chemical products.
Hygiene measures
Wash your hands before pauses and at the end of your shift. Use skin ointment to protect your hands.
Remove soiled and soaked clothing immediately and wash thoroughly before reuse.
Respiratory equipment:
Use respirators in case of long term exposure or when extraction is poor. Use a DIN EN 136
Filter A (organic gas and vapours) full face mask per DIN EN 141 Use of filtering equipment pre-
supposes that the ambient atmosphere contains at least 17 Vol% oxygen and that the permitted
gas limit of 0.5 Vol% has not been exceeded. Apply established regulations, including EN 136 /
141 / 143 / 371 / 372 and any applicable national regulations.
Observe all applicable national regulations, including TRGS 900, BGR 190.
Note the limit on duration of use per §19 Section 5 GefStoffV (German hazardous substances
regulation) in connection with rules for the use of respiratory equipment.
Hand protection:
Long term exposure: butyl rubber gloves. Minimum penetration time/glove: 480 min Minimum layer
thickness/glove: 0.7 mm
Short term exposure (spray protection): nitrile rubber gloves. Minimum penetration time/glove: 30 min
Minimum layer thickness/glove: 0.4 mm Glove of this type are available from various manufacturers.
Observe the manufacturer's recommendations in relation to minimum layer thickness and penetration
time, and be aware of any special conditions in the workplace.
Eye protection:
Protective glasses
SECTION 9: Physical and chemical properties
9.1
Information about basic physical and chemical properties
State:
fluid
Form:
fluid
Particle size:
n/a
Colour:
light
yellow
Odour:
lightly
perceptible
Odour threshold:
n/a
pH:
approx. 10 (20 °C) Method: DIN 19268 Determined undiluted.
Melting point:
approx. -28 °C Method: DIN 51583
Solidification point:
approx. -23°C, Method: ASTM D 1177
Boiling point:
approx. 104 °C Method: ASTM D 1120
Flash point:
Non-flammable (water based)
Evaporation rate:
n/a
Flammability
Lower explosion limit: n/a
Upper
explosion
limit:
n/a
Class number:
n/a
Minimum ignition energy: n/a
Vapour pressure:
< 0.1 kPa (20 °C) Method: Calculated per Syracuse.
The data apply to the main component.
Relative vapour density
in air:
n/a
Solubility in water:
(20 °C) soluble
Miscibility
with
water:
Soluble in ... :
Fat n/a
n-Octanol/water
distribution
coefficient (log Pow): n/a
Ignition temperature: approx. 420 °C Method: DIN 51794
Self-ignition temperature: n/a
Thermal decomposition: > 200 °C Method: DSC measurement in nitrogen
Viscosity (dynamic):
approx. 8 mPa.s Method: calculation
Viscosity (kinematic): approx. 7.4 mm2/s Method: DIN 51562
Explosive properties:
Explosive per EU access law: n/a
Oxidising properties: n/a
9.2
Other information
Density:
approx. 1.08 g/cm3 (20 °C) Method: DIN 51757
Bulk density:
n/a
