39
Installing the mounting rack
Tile roof, type B:
Sloped roof installation, horizontal
B = 2,5 cm
A = 7 cm
Install fasteners
•
Start with the safety brackets that
prevent the manifold and bottom rail
from slipping. Remove the right-angle
clamp from the fastener. It is not re-
quired here. Screw the bolt and the
washer back onto the Pressix chan-
nel.
•
Insert
the safety bracket for the mani-
fold to the lower mounting rail at 90°
and at a distance
A
from the end of
the rail.
Press on the bolt and tight-
en it.
•
Insert the safety bracket for the bot-
tom rail at the opposite end at 90°
and at a distance
B
from the end of
the rail. Press on the bolt and tighten
it.
•
Insert a fastener for the manifold into
the mounting rail and position it so
that it is flush with the upper edge of
the mounting rail. Press on the bolt to
snap the fastener into place.
•
Insert the fastener for the bottom rail
flush with the lower end of the mount-
ing bracket and line it up. Press on
the bolt to snap the fastener into
place. To keep the fastener in place,
hand tighten the nut by two or three
turns; do not tighten permanently yet.
•
All other
fasteners for
the manifold
and bottom rail shall be mounted to
the two ends of the mounting rail as
described above.
Inspection
After assembling the fasteners,
double check their height and posi-
tion. All fasteners shall be lined up
at the same level. Fasteners and
mounting rails shall always be par-
allel and perpendicular to the roof
covering. Reposition the mounting
rails on the Z-brackets to make any
necessary adjustments. Loosen the
upper Z-bracket bolts that connect
to the mounting bracket and adjust
the mounting rack. Retighten the
bolts.
