18
GENERAL ADVICE
It is advisable to clean when the appli-
ance is cold and especially for cleaning
the enamelled parts.
Avoid leaving alcaline or acidic sub-
stances (lemon juice, vinegar, etc.) on
the surfaces. Avoid using cleaning prod-
ucts with a chlorine or acidic base.
ENAMELLED PARTS
All of the enamelled parts must be
washed only with a sponge and soapy
water or with non-abrasive products.
Dry, preferably, with deer skin.
HOT PLATE
Foods burned on the hot plates must
always be cleaned dry.
Do not use water to avoid the forming
of rust. Be careful with the central feeler
of the automatic plates, it must never be
shined and must only be cleaned with a
damp cloth.
After its use, pour a bit of oil onto the
warm plate and rub with a cloth.
Always switch the cooker off at the
mains isolating switch before clean-
ing or touching any electrical part.
BURNERS, GRATES AND RACKS
These parts may be removed and
washed with suitable products.
The burners and their caps must be well
dried after cleaning and put back per-
fectly into their slots.
It is very important to verify the position-
ing of the burner-caps because a mis-
placing in their slots can cause serious
damage.
In the appliances with electrical ignition
for the burners, verify that the electrode
is always cleaned well as to permit the
regular snap of the spark.
8 - CLEANING AND MAINTENANCE
OVEN
The oven must always be cleaned after
every use, using suitable products and
keeping in mind that its operation for 30
minutes on the highest temperature elim-
inates most grime reducing it to ashes.
The clean-up of the oven with catalytic
self-cleaning enamel is done automati-
cally during cooking, and therefore no
intervention is necessary.
Only when the grime is particularly resis-
tant it is advisable to increase the clean-
ing time leaving the electrical elements
on at the maximun temperature, with the
oven empty. It is mandatory not to use
abrasive substances so as not to dam-
age the self-cleaning coating.
Fig. 8.1
OVEN DOOR
The oven door is cleaned in the same
way that is advisable for the enamelled
surfaces.
The internal glass of the oven door can
be easily removed for cleaning by
unscrewing the two lateral fixing screws
(fig. 8.1).
SUBSTITUTION OF THE OVEN LAMP
Before replacing the oven lamp, make
sure to disconnect the appliance mains.
The light bulb must be a type resistant
to high temperatures (300° C).
Summary of Contents for EC 530
Page 35: ...35 Identification label...
