Power Spot 575IE II™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page
18
In the case of the Power Spot 575IE II™, which is a 16 channel fixture, you should set the
starting DMX address of the first unit to 1, the second unit to 17 (16 + 1), the third unit to
33 (16 + 17), and so on.
Note:
During start-up the Power Spot 575IE II ™ will automatically detect whether a DMX
data signal is being received or not. If DMX data signal is being received, the display will
show
"A.XXX" (XXX
representing the actual DMX address). If the fixture is not receiving a
DMX signal the display will flash
"A.XXX" (XXX
representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3 PIN XLR plug (cable with DMX signal from controller) is not connected
or is not inserted completely into the DMX input jack.
-
The DMX controller is switched off or defective.
-
The DMX cable or connector is defective.
-
A DMX terminator has been inserted into the last fixture in your DMX chain.
